Three steps. No tools.
The mount goes on once. After that, emblems swap in seconds.
1. Clean the surface
Wipe the area with isopropyl alcohol and let it dry completely. Skip this and the adhesive will not bond properly.
2. Position and press the mount
Peel the backing. Place the mount where you want it. Press firmly for 30 seconds.
Do not install below 50°F. Allow 24 hours before the first swap so the adhesive can fully cure.
3. Snap on the emblem
Line it up and let the magnet do the rest. To change designs, pull the emblem straight off and set the next one on.
Removing the mount
[NEEDS TESTED PROCEDURE - do not publish until confirmed]